Little invention: Tower of CDs
Translation of the original in Catalan. Read it in: CatalàCastellano
In the article: Building a CPD (Data Processing Centre) at home a
problem is described when it comes to accessing the 'removable' storage resources of the pcs in the CPD. To solve that, what we did was buy a semi-tower ATX case with a front panel of 8 free 5'25" slots to place everything we needed: CDs, DVDs, USBs, Firewire, MMC/SD, CF, MS, SM, audio, power and HD leds, power and reset buttons. All that had to be available to the two workstations in the CPD which obviously are not directly accessible from the study.
With all that came the following little invention:

Let's go step by step, how we made the invention, well it's not that difficult, it just takes a bit of patience.
- We buy a tower with 8 5'25" slots (~40� at http://www.big-computer.com)

- We install the CDs and DVDs, then we place the IDE to USB adapters (~30�/unit at http://www.cablematic.com)


- We install the 8 in 1 adapter: flash memories, 2xUSB, 1xFirewire, 2xAudio this adapter we'll use for my computer, for Daphne's computer what we'll do is use the 2xUSB and 2xAudio that the case itself already has:

- It's time to make the 'cool' little inventions, in order to have a power and reset button, plus the power and hard disk leds, what we did is the following:
4.1) We take a male DB9 connector and solder 8 cables to it that we'll connect to the motherboard of each computer
(Daphne Motherboard Diagram). In order not to get tangled making cables with special connectors for the motherboards, we cut cables with the connectors from other old computer cases and soldered them to the DB9 connector following this diagram:

4.2) Then we took a network cable and made it as long as we needed, taking advantage of the 8 wires it has we soldered two female DB9 connectors at each end, following a 1 to 1 diagram, without complicating our lives and leaving the same pin disconnected as in the previous diagram.
4.3) Once in the 'Tower of CDs' we set up two slots with 4 off-on pushbuttons (2xPB305BR and 2xPB305BA ~0'7� at http://www.ondaradio.es) and 4 LEDs (2xILPN3R and 2xILPN3V ~0'15� at http://www.ondaradio.es) and with a little bit of logic we went on connecting the cables we had soldered to the female DB9 connector (from the CDS case) to the pushbuttons or to the LEDs as needed. As you can see in the DB9 diagram there is no power for the power LED, that's because we don't want to control whether the computer is on, we'll simply take 12V from inside the case to power the two LEDs, that yes, placing first a 10k resistor pq otherwise the LEDs go PUF!!!!



- We connect the USB cables to the corresponding PCs and the audio cables too.

- And in the end, we get:

- AND THE MOST IMPORTANT THING!!!
MANY THANKS XAVI!!!
Without you my ideas couldn't become reality!!!!
1 comment
Comments from the old blog, as they were written. Comments are closed.
lalala
muito bom