Linux pre-installation

Translation of the original in Catalan. Read it in: CatalàCastellano

This week at work we had

to install a linux... well,

even if it sounds like a joke it took us

ages to be able to start the

installation.

The steps we ended up following to

start the installation, even if it

sounds like a joke, are these:

  1. We tried a typical

installation after putting a CD in

the computer and booting with the two

obligatory floppies, the CD even though it

was detected told us that we did not have a CD

inside the drive when the CD was actually there

and it wasn't scratched or anything.

  1. Since the HD was 1Gb we decided

to copy the slack CD into the HD on another

computer.

  1. The other computer had w2k and

this one doesn't come with fdisk, that is, we

couldn't partition the 1Gb HD to

copy slack onto it.

  1. On another computer we made a

boot floppy with a fdisk to

partition the HD.

  1. We boot w2k and get ready to

copy the HD after formatting the

new partition.

  1. Then w2k goes and tells us if we

want to format the slack CD ??????

ein!!!! so it didn't recognize the CD.

  1. We decide to make a crossover network cable

to connect the laptop at 100Mbps

with the w2k computer since the

laptop does detect the slack CD

with the DVD drive.

  1. The crimping tool to make the cable

turns out to be in the car and we have to go down

to fetch it.

  1. We make the cable and start the copy,

after about 10min of copying and when

only 3 directories are left the copy

crashes!!!! great great!!!

  1. we clean the CD and try it

again, this time. At last it copies fine.

  1. we get ready to mount the

FAT32 drive with the slack copy after

booting with the two obligatory

slack floppies and it gives us an error: too

many levels of symbolic links. mount

table corrupt.

  1. Well, whoever understands it can

explain it to me. We restart the computer and

try again and at last it seems that

the installation starts....BUF!!!!!

Blimey, blimey, blimey!!! 12 summarized steps

and a ton of hours to be able to

start a slack installation.

Lucky that this isn't always like that, otherwise

honestly there is enough to make you ditch the bloody

linux.

NOTE: obviously the computer where we

installed linux wasn't new. It was a

P166MMX with 16Mb RAM and 1Gb HD.

1 comment

Comments from the old blog, as they were written. Comments are closed.

  1. Oriol Rius

    Per cert, l'article es veu tot tirat cap a un

    costat gràcies al fantastic control+n q aplica

    el "super" konqueror per la patilla als salts d

    línia dels formularis. Sort q va com un cristal

    sinó...